Carrier Air Conditioner Not Heating, Why It Happens

A Carrier air conditioner not heating on a cold morning can leave the whole house chilly.

Some of what people report as a fault is normal heating behaviour, such as the fan waiting to start or a pause for defrost. Other cases point to settings, airflow or a genuine fault. This guide helps you tell the difference and explains the repairs.

Is your model a reverse cycle unit?

Most Carrier wall splits sold for homes are reverse cycle, which means they can heat as well as cool. Some cooling only models exist, though, and they cannot heat at all.

Check the model number on the rating label, or look at the remote for a heat mode symbol. If the remote has no heat mode, the unit may be cooling only. Our models page explains how to read Carrier model numbers.

Is the remote set to heat?

Make sure the remote shows heat mode. Auto mode chooses heating only when the room is cooler than the setting, so on a mild day it may cool or just run the fan.

Next, look at the target temperature. Heating only runs while the room sits below that number, so raise it to two or three degrees above how warm the room feels now.

Why does the fan not blow straight away?

When heating starts, the indoor coil is cold. Carrier units use an anti cold air feature that holds the indoor fan back until the coil warms, so you do not get a cold draft. Many displays show an icon during this time.

That wait can last several minutes on a cold morning. It is normal, so give the system time before deciding it has failed.

Why does heating stop for a few minutes?

On cold, damp mornings, frost builds on the outdoor coil while the system heats. Every so often, the system pauses heating and warms the outdoor coil to melt the frost. The display often shows a defrost icon, the indoor fan may stop and steam may rise from the outdoor unit.

That defrost cycle is normal and usually lasts a few minutes. Heating resumes once the coil is clear.

How cold can it be outside before heating struggles?

Reverse cycle heating draws heat from the outside air, so output falls as the air gets colder. Carrier product information for the Allure range states the system continues heating down to minus 15 degrees outside, which covers Sydney winters.

Even so, on the coldest mornings in the western suburbs, frequent defrost cycles reduce the heat reaching the room. Starting the system earlier helps.

Are the filters clean?

Dust packed into the filter mesh slows the air crossing the indoor coil. In heat mode, less air means less warmth reaching you, and the refrigerant pressure inside the coil climbs, which can trigger a protective stop.

Lift the front panel and look. Grey, furry mesh needs washing, and the steps for Carrier wall splits are in our guide to washing the filters.

Could Follow Me be affecting heating?

Follow Me moves the temperature sensing job from the indoor unit to the handset. So a handset resting beside a lamp, on a sunny sill or right under the warm outlet reports a cosy room, and heating backs off early.

Keep the handset on a table near where people sit, well clear of heat sources. Alternatively, turn the feature off and let the indoor sensor take over again.

Could Active Energy Control be limiting output?

Allure models include Active Energy Control, a setting that limits how much of the rated output the system may use. On a chilly evening, a unit held back to half its output can fall well short of a comfortable room.

Look on the handset for the capacity setting and return it to the full level for winter evenings.

Is the outdoor unit running?

During heating, the outside unit should be busy, with its fan turning and the compressor humming. Stand near the fan and the air feels chilly, since the unit is pulling warmth out of the winter air.

When nothing outside stirs for ten minutes or more, look at the isolator switch beside it and the breaker in your switchboard. If both are on, our page on an outdoor unit that will not run lists the usual suspects.

Is the outdoor coil covered in ice?

Light frost that clears during defrost is normal. A thick block of ice that never clears, or ice building on the base and pipes, is not.

Heavy icing can come from a faulty outdoor coil sensor, a defrost fault, a weak outdoor fan or low refrigerant. Switch the system off, let the ice melt and book a check. Our F2 page explains the outdoor coil sensor.

Is the outdoor unit draining properly?

Defrost cycles produce water, which drains from the base of the outdoor unit. If mulch, soil or debris blocks that drainage, water can pool and refreeze, building ice under the coil.

Keep the base clear and make sure water flows away. In very exposed spots, a technician can advise on raising the unit.

Is a code showing on the display?

Any letters on the indoor panel deserve a note on paper or a quick photo. Then match them against our Carrier code list. Heating can stop for outdoor sensor faults such as F1 and F2, fan faults and compressor protection.

When a code reappears after one careful power cycle, the fault is real and needs testing on site.

Could the reversing valve be stuck?

Reverse cycle systems use a reversing valve to switch between cooling and heating. If the valve sticks in the cooling position, the system blows cool air in heat mode. If its control coil or signal fails, the same thing can happen.

A technician can test the valve coil and check the refrigerant temperatures to confirm. Our blowing warm air page covers the opposite situation in cooling.

Could the system be low on refrigerant?

Leaks hurt winter performance just as much as summer performance. Warm air turns lukewarm, run times stretch out and the outside coil frosts over more often than it should.

Topping up alone will not hold. The leak has to be located and sealed, then the circuit evacuated and weighed back to its correct charge, as described on our regas page.

Is heat escaping from the room?

A perfectly healthy unit still loses the battle if warmth leaks away faster than it arrives. Shut doors to rooms nobody is using, pull heavy curtains once the sun goes down and keep external doors closed.

Tall ceilings, big glass areas and thin insulation all raise the heating demand. When a room has struggled every winter since the unit went in, the capacity chosen at installation may simply be too small for the space.

Why does the room feel cold near the floor?

Warm air rises, so heat tends to collect near the ceiling. Aim the louvres downward in heat mode, so the warm air reaches the floor before rising.

A ceiling fan on a low reverse setting, where fitted, can also help push warm air back down.

Should you try a reset?

A single power cycle can clear a confused board. Switch off at the handset, then turn the breaker off and count five minutes before switching it back on. Select heat mode again and allow ten minutes of warm up before you judge the result.

Weak heat or a returning code after that means it is time for a visit. The full method sits in our power cycle guide.

How does a technician diagnose a Carrier air conditioner not heating?

On a heating call, the technician looks at the handset settings, the filters and the airflow before anything else. Next, they compare the temperature of the air going into the indoor unit with the air coming out, and they watch the outdoor unit through a defrost cycle where the weather allows.

Gauges then show the refrigerant side of the story. The reversing valve, the outdoor sensors and both fans get tested if the readings point their way.

What repairs fix poor heating?

Winter heating repairs usually fall into one of these groups.

  • Washing the filters and cleaning both coils and the fan barrel.
  • Fitting a new outdoor sensor so defrost works properly again.
  • Sealing a refrigerant leak and recharging by weight.
  • Replacing the reversing valve coil or the valve itself.
  • Fitting a new outdoor fan motor.

You hear the cause and the price before any of this work begins.

How much does it cost to fix?

Cleaning and servicing cost the least. Sensors and fan motors land in the middle of the range. Reversing valve and leak work cost the most, because the refrigerant has to be recovered and replaced.

Testing comes before any quote, and our price guide sets out how call outs and repairs are charged.

What is 8 C heating and does it matter here?

Some Carrier models offer 8 C heating, which keeps an empty room at around 8 degrees. If someone left that feature on, the room will stay cool, since the system only aims for that low temperature.

Check the display for the 8 C heating icon and switch the feature off to return to normal heating.

Can servicing help with winter heating?

Yes. A service before winter cleans the coils, checks the outdoor fan and sensors and confirms the system heats as it should. It also catches small leaks before cold weather exposes them.

Booking in autumn avoids the rush when the first cold snap arrives.

Why does heating feel weaker than an old gas heater?

A gas heater blasts very hot air from one spot, while a reverse cycle split delivers a larger volume of gently warm air. The air from a split may feel only warm on your hand, yet it can heat the whole room steadily and efficiently.

So judge the system by the room temperature after half an hour, not by how hot the outlet air feels. A thermometer on a shelf away from the unit gives a fair picture.

Do the louvres matter in heat mode?

They matter a lot. Warm air naturally rises, so louvres pointing straight out or up send the heat to the ceiling. Aim them downward, toward the floor, so the warm air spreads through the lower part of the room first.

Swing mode can help in larger rooms, since it spreads the warm air more widely.

What about rooms that face south?

South facing rooms get little winter sun, so they start colder and lose heat faster. A split system in such a room works harder than an identical unit in a sunny north facing room.

Starting the heating earlier, keeping curtains closed on cold days and sealing draughts around doors all help.

Can a dirty outdoor coil reduce heating?

Yes. In heating, the outdoor coil collects warmth from the outside air. Leaves, dust and lint on the fins block that airflow, so the coil collects less heat and frosts over faster.

A gentle rinse from outside the unit, with water kept away from the electrical parts, helps. A professional coil clean during a service is more thorough.

Do we fix Carrier heating problems across Sydney?

Yes. We repair Carrier air conditioners that will not heat across Sydney, including the colder western and southwestern suburbs, the Hills District and the North Shore. See our areas page.

Phone 02 9071 1142 or book through our contact page. If you notice oil stains around pipe joints, mention them, because they can mark a refrigerant leak.

Frequently asked questions

Why does my Carrier unit not blow air when heating starts?

Anti cold air holds the fan back until the coil warms, which is normal.

Why does heating stop on cold mornings?

The system pauses to defrost the outdoor coil. Heating resumes once the frost clears.

Can low gas stop heating?

Yes. A leak weakens heating and cooling and can cause extra icing on the outdoor coil.

Why is my room only warm near the ceiling?

Warm air rises, so aim the louvres downward in heat mode.

Could the 8 C heating feature be on?

Yes. If it is on, the room stays at around 8 degrees. Switch it off for normal heating.

How do I book a repair?

Phone 02 9071 1142 or use our contact page.

{“@context”:”https://schema.org”,”@type”:”HVACBusiness”,”@id”:”https://carrier.sydneyaircare.com.au/#business”,”name”:”Sydney Air Care, Carrier Service”,”url”:”https://carrier.sydneyaircare.com.au/”,”description”:”Carrier air conditioner repair, service and troubleshooting across Sydney. Independent service provider, not affiliated with Carrier.”,”areaServed”:[{“@type”:”City”,”name”:”Sydney”},{“@type”:”State”,”name”:”New South Wales”}],”parentOrganization”:{“@type”:”Organization”,”name”:”Sydney Air Care”,”url”:”https://sydneyaircare.com.au/”},”telephone”:”+61 2 9071 1142″} {“@context”:”https://schema.org”,”@type”:”FAQPage”,”mainEntity”:[{“@type”:”Question”,”name”:”Why does my Carrier unit not blow air when heating starts?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Anti cold air holds the fan back until the coil warms, which is normal.”}},{“@type”:”Question”,”name”:”Why does heating stop on cold mornings?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”The system pauses to defrost the outdoor coil. Heating resumes once the frost clears.”}},{“@type”:”Question”,”name”:”Can low gas stop heating?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Yes. A leak weakens heating and cooling and can cause extra icing on the outdoor coil.”}},{“@type”:”Question”,”name”:”Why is my room only warm near the ceiling?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Warm air rises, so aim the louvres downward in heat mode.”}},{“@type”:”Question”,”name”:”Could the 8 C heating feature be on?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Yes. If it is on, the room stays at around 8 degrees. Switch it off for normal heating.”}},{“@type”:”Question”,”name”:”How do I book a repair?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Phone 02 9071 1142 or use our contact page.”}}]}
Call 02 9071 1142